Service manual

CANDoo Professional
99
The TPS setting on the early RFI's is a multi-step process:
1. First, you need to back off the idle screw so the throttle plate is closed completely.
2. Once the throttle plate is closed and the idle screw is not touching the stop, press Reset on the
RFI-TPS setting page.
3. Select Vehicle, the Write Vehicle to write the change to the MPEM.
4. Screw the idle screw in until it just touches the stop, and turn it in approximately 3 turns.
5. Check the Throttle Opening Setting; it should be between 6 and 7. If not, adjust screw to obtain
a setting between 6 and 7.
6. Check final idle speed in the water; it should be approximately 1500 RPM
3.1.2.1.2.2.4 RFI Faults Tab
CANDooPro > Vehicles > Sea-Doo Watercraft > 2 Stroke RFI Models(See 3.1.2) >
Early RFI Models (1998-2004)(See 3.1.2.1) > Working with CANDooPro(See
3.1.2.1.2) > Diagnostic Session Details(See 3.1.2.1.2.2) >
RFI Faults Tab
(See
3.1.2.1.2.2.3)
(See
3.1.2.1.2.2.5)
The RFI Faults Page:
The RFI Faults page displays the status of the faults detected by the RFI ECU. Please note that
the detection system of the RFI depends upon the engine to be running to detect most faults. Note
that the RFI Faults page displays a listing of all possible faults; only faults indicated with Active or
Occurred status are problems!
NOTE: Fault P0335, Engine Speed Signal Not Detected will always be active if the engine is
not running!