Service manual

CANDoo Professional
101
Occurred Faults
"Occurred" means that a fault became active at some time in the past, but at this moment, it is not
active.
Working with Faults.
Please follow the steps below:
Step # 1- Start engine. (Ensure your cooling water is attached, and do not run over 5 minutes or
damage to the carbon seal may result!)
The engine must be running for the fault detection system to detect faults
Step #2- Read fault table
Look for the existance of any Active and Occurred Faults.
Step #3 - Address problems noted by faults
Any Active faults must be corrected by repairing the affected component
Step # 4 - Clear faults
Press the Clear Faults button, and the Vehicle, Write Vehicle to save the changes to the MPEM
3.1.2.1.2.2.5 Engine Monitor Tab
CANDooPro > Vehicles > Sea-Doo Watercraft > 2 Stroke RFI Models(See 3.1.2) >
Early RFI Models (1998-2004)(See 3.1.2.1) > Working with CANDooPro(See
3.1.2.1.2) > Diagnostic Session Details(See 3.1.2.1.2.2) >
Engine Monitor Tab
(See
3.1.2.1.2.2.4)
(See
3.1.2.1.2.2.6)
The Engine Monitor tab:
The Engine Monitor feature allows you to monitor several engine parameters, primarily for
observing several points while the engine is running.