Service manual

CANDoo Professional
106
WARNING: Always remember to put the cap back on the diagnostic
connector when you are finished with a Candoopro session! Otherwise your
Maint light will be on and stay on!
Steps for Starting a Candoopro session with the 4_TEC watercraft:
1. Plug the USB cord into the Candoopro box and the PC. The Green Power light on the
Candoopro box should light up.
2. Plug the 9 pin connector on the 9 pin/ 6-pin harness cable into the Candoopro box.
3. Plug the 6 -pin connector on the 9-pin/6-pin harness cable into the diagnostic connector on the
PWC.
4. Start the Candoopro program. Upon launch, the program will show the following screen: