Service manual

CANDoo Professional
130
The key number shown by the popup box is the 64 bit serial number of the key. (Shown in
Hexidecimal format) Note that this only tests the microchip in the key; it does not check for a weak
magnet.
If you receive a pop up box stating " Key Not Found", try repositioning the key again on the post.
If you still receive the "Key Not Found " message after repeated tries, remove key, clean the
stainless metal contacts on the key with a pencil eraser and try again. If it still will not read, the key
is likely no good.
3.1.2.2.2.2.2.3 Erasing Keys
CANDooPro > Vehicles > Sea-Doo Watercraft > 2 Stroke RFI Models(See 3.1.2) >
Late RFI Models (2005)(See 3.1.2.2) > Working with CANDooPro(See 3.1.2.2.2) >
Diagnostic Session Details(See 3.1.2.2.2.2) > Keys Tab(See 3.1.2.2.2.2.2) >
Erasing Keys
(See
3.1.2.2.2.2.2.2)
(See
3.1.2.2.2.2.2.4)
Erasing Keys:
Often you will find that the key listing contains a number of keys that are no longer used. This can
happen over the years as keys are lost, and new keys are added without removing the old key
numbers. Candoopro makes it easy to remove these old unused key numbers.