Service manual

CANDoo Professional
137
 When the Settings page is first accessed, the TPS setting will not be displayed, because
the monitor function that detects the TPS setting is not running. Press the Start Monitor
button to observe the TPS reading.
 The TPS reading should be zero. If not zero, then you should reset the TPS.
 Press the Reset button in the Reset TPS section.
 A popup box will appear to instruct you to remove the key to complete the TPS setting
operation. Follow the instructions in the popup box.
 After you remove the key per the instructions, you can put the key back on and ensure that
the TPS setting is zero.
To Change the Ignition Angle Timing Offset setting:
 Please refer to your Service Manual for the proper procedure to determing the proper
ignition angle.
 Once you have determined the proper angle, select the proper angle setting from the drop-
down box and highlight the value.