Service manual

CANDoo Professional
157
o Green is detected or communicating
o Red indicates no vehicle is detected or is not communicating
 Number of Connections indicates the total number of modules on the Vehicle that are
communicating with Candoopro system
o Zero indicates no modules are communicating
o One is typical for most Carburated, DI, and RFI vehicles (MPEM)
o Two is typical for early 4-tec models (ECU and MPEM)
o Three is typical for some later 4-tecs (ECU, MPEM, Cluster)
o Late model iS vehicles can have 5 modules communicating
 Current Process shows the current activity
At this point, the CANDooPro program is looking for communication from the ski, and the
zero indicates that it does not have any communication with a ski.
5. Put a DESS key/lanyard on the DESS post on the ski. (Does not need to be programmed to the
ski; it can be any DESS key..) You should hear a single beep if the key has not been programmed
in memory, two beeps if the key has been programmed into the MPEM.
6. The CANDooPro program should detect the DI ski, the Vehicle Connection Status indicator
should change from red to green, and the Current Activity bar at the lower left should indicate "DI
Detected "
7. Select the Vehicle tab at top, select "Read Vehicle ", and the CANDooPro system should begin
to read the information from the MPEM.
8. Once the information is read from the MPEM, the main Vehicle screen should appear, and the
Current Activity bar at the bottom should alternate between "DI Detected" and "Real Time
Monitor". If you are using the Limited version of CANDooPro and this is the first time you have
connected to this watercraft, you will be prompted if you wish to have this watercraft count towards
your total available VIN numbers. Pressing Yes will add this watercraft to your list of VIN's used
You are now ready to begin a diagnostic session.