Service manual

CANDoo Professional
171
3.1.3.2.2 Resetting Maintenance Light
Resetting the Maintenance Light
There are two causes for the Maintenance Light to be blinking on a DI:
1. The internal Service Interval counter indicates that the watercraft is due for maintenance. (It is
simply a Maintenance reminder light)
2. The DI Engine Management System detects an active fault.
It is recommended that anytime the Maintenance light is blinking to try resetting the Maintenance
Reminder light first.
To turn off the Maintenance Reminder light:
Press and hold the SET button on the steering pad for 2 seconds.
To turn off the Maintenance light due to faults:
If pressing the SET button in the procedure outlined above doesn't stop the light from blinking, then
the DI engine Management System detects an Active Fault. The Active Fault must be fixed to turn