Service manual

CANDoo Professional
172
off the blinking light. Please refer to the procedures outlined in the DI Faults Tab section to
diagnose which fault is active.
3.1.3.2.3 Diagnostic Session Details
Instructions for Diagnostic Session Details using the CANDooPro
system:
To start, first " Read" the MPEM as detailed in the "Connecting & Starting a Session " section,
and refer to the information contained in each respective tab.
3.1.3.2.3.1 Vehicle Tab
CANDooPro > Vehicles > Sea-Doo Watercraft > 2 Stroke DI Models(See 3.1.3) >
Working with CANDooPro(See 3.1.3.2) > Diagnostic Session Details(See 3.1.3.2.3) >
Vehicle Tab
(See
3.1.3.2.3)
(See
3.1.3.2.3.2)
Using features in the Vehicle tab:
To change the VIN number or enter a VIN in a new MPEM
 Select and delete the current VIN that appears in the box
 Type in new VIN number
 Select Vehicle, and click Write Vehicle to write the change into the MPEM
Please note the the Change VIN feature only available on CANDooPro Unlimited version. If you
are using the Limited version of CANDooPro on a new MPEM, CANDooPro will prompt you to enter
in a VIN number for the ski. (CANDooPro uses this VIN number for tracking purposes) Please
note that you can put anything you want into the VIN number field, but please be aware that once
you enter this information using the Limited system, you cannot change it anymore.)
To reset the Rental Hours
 Click the Reset box next to the Rental Hours
 Rental Hours should reset to zero
 Select Vehicle, and click Write Vehicle to write the change into the MPEM
To reset the Service Hours
 Click the Reset box next to the Service Hours
 Service Hours should reset to zero
 Select Vehicle, and click Write Vehicle to write the change into the MPEM
To change the Owner Information section