Service manual

CANDoo Professional
178
The CANDooPro program will write the information into the MPEM and read the information back
from the MPEM to ensure the information was written properly.
To Erase All Keys:
Pressing the "Erase All Keys" button will remove all keys from the listing.
Note that if you erase all keys, you must add back at least one key to the
listing before writing the change, otherwise unpredictable results may occur!
After you have added one or more keys to the listing, then you can write the change into the MPEM
with the Vehicle, Write Vehicle command.
3.1.3.2.3.2.4 Adding New Keys
CANDooPro > Vehicles > Sea-Doo Watercraft > 2 Stroke DI Models(See 3.1.3) >
Working with CANDooPro(See 3.1.3.2) > Diagnostic Session Details(See 3.1.3.2.3) >
Keys Tab(See 3.1.3.2.3.2) >
Adding New Keys
(See
3.1.3.2.3.2.3)
(See
3.1.3.2.3.2.5)
Adding Keys:
The DI MPEM can store up to 8 keys. To add a new key, you must have an available key slot
(empty row) in the key chart. If the chart has all 8 keys filled, you must erase a key before
CANDooPro will allow you to add a new key.
To Add a new Key:
Insert the key you wish to add to the MPEM onto the post on the CANDooPro interface box.
Ensure the key is pushed all the way down onto the post and is square on the post.