Service manual

CANDoo Professional
185
Choose a value higher or lower than your current setting (depending upon the offset of the mark
from the pointer) and press Set.
Note the direction the mark has moved relative to the pointer, and if your change moved the mark
in the right direction. This will give you an idea if you are moving in the right direction and the
magnitude of how far off you are.
Try a setting in the proper direction, and continue until the marks align perfectly.
Once you have the proper setting, simply press the Unlock (enable advance) butting, and you are
done.
3.1.3.2.3.4 DI Activate Tab
CANDooPro > Vehicles > Sea-Doo Watercraft > 2 Stroke DI Models(See 3.1.3) >
Working with CANDooPro(See 3.1.3.2) > Diagnostic Session Details(See 3.1.3.2.3) >
DI Activate Tab
(See
3.1.3.2.3.3)
(See
3.1.3.2.3.5)
DI Activate Features: