Service manual

CANDoo Professional
186
The DI Activate page allows you to dynamically test a number of components to simplify
troubleshooting
NOTE: Most of the Activate features are used while engine is off unless otherwise specified!
Description of Activate Features:
 Pressing the Rave Solenoid button activates the Rave solenoid. Listen for a
clicking sound.
 Pressing the Beeper button tests the Beeper
 Pressing the High Temp Signal causes the Info Center to display High Temp
 Pressing the Fuel Pump button activates the fuel pump for a few seconds (useful
for checking fuel pressure)
 Pressing the Maintenance Signal button displays MAINT on the Info Center gauge.
 The Stop Engine button will cause a running engine to stop
 Pressing the Display 3000 button causes the Info Center to display 3000. (very
short time)
 The Oil Bleed button is used to bleed the oil injection system after repair. It simply
deactivates the throttle. To use the oil bleed feature, start engine, press the oil
bleed button, and press throttle to wide open. The engine should stay at idle even
though the throttle is pressed wide open. This pulls the oil injector wide open to
allow the system to bleed.
 The Fuel Pressure Relief button goes through a sequence of activating the fuel
and air injectors to relieve the pressure in the fuel lines before disassembly.