Service manual

ManualsBrandsSea-doo ManualsBoat2005 3D RFI

221

222

223

224

225

226

227

228

229

230

CANDoo Professional

223

3.1.4.3.2 Diagnostic Session Details

Instructions for Diagnostic Session Details using the CANDooPro

system:

To start, first " Read" the ECU as detailed in the "Connecting & Starting a Session " section, and

refer to the information contained in each respective tab.

3.1.4.3.2.1 Vehicle Tab

CANDooPro > Vehicles > Sea-Doo Watercraft > 4 Stroke (4-TEC) Models(See 3.1.4) >

Working with CANDooPro(See 3.1.4.3) > Diagnostic Session Details(See 3.1.4.3.2) >

Vehicle Tab

(See

3.1.4.3.2)

(See

3.1.4.3.2.2)

Using features in the Vehicle tab:

To change the VIN number or enter a VIN in a new ECU

 Select and delete the current VIN that appears in the box

 Type in new VIN number

 Select Vehicle, and click Write Vehicle to write the change into the ECU. A box will pop

up and ask you to remove the key to complete the write operation. Please follow the

instructions, and make note that on 2007+ models you need to remove, reinstall, and

remove the key again to complete the write operation. (NOTE: On 2009+ watercraft with

the iControl system, you do not have to remove the key. A box will not pop on on these

models)

 Please note the the Change VIN feature only available on CANDooPro Unlimited version.

If you are using the Limited version of CANDooPro on a new ECU, CANDooPro will prompt

you to enter in a VIN number for the ski. (CANDooPro uses this VIN number for tracking

purposes) Please note that you can put anything you want into the VIN number field, but

please be aware that once you enter this information using the Limited system, you cannot

change it anymore.)

To reset the Rental Hours

 Click the Reset box next to the Rental Hours

 Rental Hours should reset to zero