Service manual

CANDoo Professional
235
 Always refer to your Service Manual for the proper instructions for your watercraft. In
general, ensure that the throttle cable has slack, and that the throttle is closed against the
idle stop screw, by opening and closing the throttle several times. Do not alter the throttle
stop screw setting!; just make sure the throttle is closed.
 When the Settings page is first accessed, the TPS setting will not be displayed, because
the monitor function that detects the TPS setting is not running. Press the Start Monitor
button to observe the TPS reading.
 The TPS reading should be zero. If not zero, then you should reset the TPS.
 Press the Reset button in the Reset TPS section.
 A popup box will appear to instruct you to remove the key to complete the TPS setting
operation. Follow the instructions in the popup box.
 After you remove the key per the instructions, you can put the key back on and ensure that
the TPS setting is zero.
To Reset Throttle Position Sensor (TPS) on 2009+ models with Bosch ECU
(iControl watercraft):
 Always refer to your Service Manual for the proper instructions for your watercraft.
 The idle speed on this model is controlled actively by the electronic throttle body, so the
throttle butterfly is always open sufficiently to allow proper idle.
 The TPS value on this model will never be zero after reset; typically it will show a value
around 9-10.
 A pop-up box will not show after you reset the TPS, as this is done actively by the ECU,
and you do not need to Write the ECU to store the new value.