Service manual

CANDoo Professional
237
Marrying Clusters :
Starting in 2006, Sea Doo implemented a security feature to require matching, or marrying the
cluster to the ECU, since the cluster reports running hours. (To prevent the user from putting on a
cluster with low hours). The ski will not start if you put a new cluster on these models, and you
must marry the cluster to the ECU.
To marry the cluster:
 Read the vehicle, and go to the Settings tab
 A section indicating "new cluster detected, do you want to marry it?" will appear.
 Check the box, and Write the vehicle. The new cluster will now be married to the ECU
 Make sure the ski starts, if not, check to see if the message appears in the settings tab and
try again.
Warning: Starting in 2008, BRP began selling clusters with no internal profiling software in them.
These replacement clusters are for 2006-2012 models. The appropriate software must be loaded
into them before they will work properly. This is done with the BUDS dealer software. CANDooPro
will not load this software, as it is the copyrighted property of BRP