Service manual

CANDoo Professional
242
For some Occurred Faults, sometimes you need to clear the fault, and run the watercraft again to
see if it is a current issue.
Step #4 - Clear the faults
To clear the faults, you simply press the Clear Faults button. The Faults will be cleared in the
modules
Step #5 - Run watercraft to verify problems are fixed
It is always advisable to run the watercraft again after fixing and clearing faults to ensure that all
problems are fixed. If you are running the watercraft while CANDooPro is connected, you can hit
the Refresh button at any time to check for new faults.
3.1.4.3.2.5 Activate Tab
CANDooPro > Vehicles > Sea-Doo Watercraft > 4 Stroke (4-TEC) Models(See 3.1.4) >
Working with CANDooPro(See 3.1.4.3) > Diagnostic Session Details(See 3.1.4.3.2) >
Activate Tab
(See
3.1.4.3.2.4.2)
(See
3.1.4.3.2.6)
Activate Features:
The Activate page allows you to dynamically test a number of components to simplify
troubleshooting
NOTE: Most of the Activate features are used while engine is off unless otherwise specified!