Service manual

CANDoo Professional
271
Please note that if you change these values, you must restart the program in order for the
changes to take effect!
3.3.1.2 Connecting & Starting a session
Connecting & Starting a Session on the 1999 to 2003 STX-1100 DI
Ultra 130 2 stroke model:
Connecting the Diagnostic Cable to the Jet Ski:
Steps to connect:
1. Remove the seat, and look for the Yellow 6-pin diagnostic connector at the rear of the engine
bay, just under the seat. It will have a dust cap on it with a looped single wire on the end of it:
2. Remove the dust cap from the diagnostic connector, and attach the STX-1100 DI Main
Diagnostic cable to the yellow diagnostic connector on the ski.