Service manual

CANDoo Professional
285
The Config Tab:
The Config page allows you to change the overall program numbering system between US and
Metric values, as well as allowing you to personalize the "Serviced By " setting.
Please note that if you change these values, you must restart the program in order for the
changes to take effect!
3.3.2.2 Connecting & Starting a Session
Connecting & Starting a Session on the 2003-2012 STX-12F/15F 4-stroke Models:
Connecting the Diagnostic Cable to the Jet Ski:
Steps to connect:
1. Locate the 4-pin Diagnostic Connector, which is located in the engine compartment adjacent to
the voltage regulator assembly. The connector is black, and has a cap on it with yellow sealed
inserts(connector shown with dust cap removed):
2. Remove the dust cap, and plug the Candoopro Kawasaki Main Diagnostic cable into this
connector.