Service manual

CANDoo Professional
48
7. Reading Information from the MPEM
After sliding the DESS adapter onto the post, click the Vehicle tab at the upper toolbar of the
screen, and click "Read Vehicle".
The CANDooPro system will now read the information from the MPEM. On most DESS skis, you
will also hear a series of beeps from the buzzer during the transfer of data.
IMPORTANT NOTE: You have a very limited amount of time to read the vehicle after you
slide the DESS adapter onto the post, typically 15 seconds. If you do not read the vehicle
within this time window, the green vehicle icon will change back to red, and the Current
Process will change back to "Looking for Vehicle". You can either remove the DESS
adapter and slide it back on to reactivate the MPEM, or simply just press the Start button.
3.1.1.2 Working with CANDooPro
The subjects contained in this section describes the process for
working with MPEM data using the CANDooPro system.
In general, you must go thru the following steps to change or modify information in the MPEM:
1. Read the MPEM, using the Read Vehicle command contained in the Vehicle tab of the
program
2. Modify the information (for example, reset service hours, add new key, etc)
3. Write the changes back to the MPEM, using the Write Vehicle command contained in the
Vehicle tab of the program:
3.1.1.2.1 Overview of capabilities
CANDooPro > Vehicles > Sea-Doo Watercraft > 2 Stroke Carbureted Models >
Working with CANDooPro(See 3.1.1.2) >
(See
3.1.1.2)