Service manual

CANDoo Professional

 (NOTE: there is usually not any good reason to change the default value!)

To change Ignition Settings:

CAUTION: CANDooPro gives the capability to change several ignition settings.

The only documented setting is the Ignition Correction setting. Please refer to

the Service Manual for the model ski you are working on, and follow the procedure

noted in the manual for properly setting the ignition offset number into the Ignition

Correction setting. Many models also have a Curve and Limit setting available,

but these are not documented anywhere, and we have no idea what effect these

have, or the amount of change. Changing these values could have a detrimental

result, including catastrophic engine failure due to excessive ignition advance.

The feature is provided for tuners and racers that have the means to properly

assess the effects of these changes.

To change Ignition Correction setting:

 Using the procedure outlined in your service manual, determine the proper correction factor

required to obtain the proper ignition setting

 Move the slider on the Correction setting to the proper value (1-8)

 Select Vehicle, and click Write Vehicle to write the change into the MPEM

 Follow the procedure in the manual to re-check that the new value is correct. If not, re-

check and try a new setting, writing it back to the MPEM.