Service manual

CANDoo Professional
96
NOTE: If a key is not on the post, is not properly seated on the post, or is not a good key,
you will see an error message "Key Not Found".
Once you have added the key to the list, you must now write the new key into the MPEM. Select
"Vehicle" in the upper tab, then "Write Vehicle".
The CANDooPro program will write the information into the MPEM and read the information back
from the MPEM to ensure the information was written properly.
3.1.2.1.2.2.2.5 Disabling DESS
CANDooPro > Vehicles > Sea-Doo Watercraft > 2 Stroke RFI Models(See 3.1.2) >
Early RFI Models (1998-2004)(See 3.1.2.1) > Working with CANDooPro(See
(See