Specifications

Disconnect the water supply hose
used to cool the magneto. It features
a quick connect fitting. Press both
tabs and pull fitting in order to discon-
nect hose.
This hose is located at the bottom of
the magneto cover beside the engine
support.
F22E02Y
1
1. Press tabs here and disconnect hose
CAUTION:
Pull out fitting carefully.
Take care not to damage it against
the bilge bottom surface.
Water should flow out of the fitting
(magneto cooling circuit) and hose
(crankcase heat exchanger).
NOTE: It may be necessary to posi-
tion the end of the hose in a lower area
of the bilge to allow proper drainage.
1
2
F17E0BY
TYPICAL
1. Fitting
2. Hose
Reconnect hose when done.
Body Rinsing/Repair
Wash the body with soap and water
solution (only use mild detergent).
Rinse thoroughly with fresh water.
Remove marine organisms from the
hull.
CAUTION:
Never clean fiberglass
andplasticpartswithstrongdeter-
gent, degreasing agent, paint thin-
ner, acetone, etc.
For small gelcoat repairs, refer to an
authorized Sea-Doo dealer. Replace
damaged labels/decals.
Propulsion System
Lubricant in jet pump reservoir should
be drained and reservoir cleaned. Re-
fer to an authorized Sea-Doo dealer for
this operation.
Grease lubrication point(s) of propul-
sion system as explained in MAINTE-
NANCE section.
Fuel System
Sea-Doo fuel stabilizer (or equivalent),
can be added in fuel tank to prevent fu-
el deterioration and gumming. Follow
manufacturer’s instructions for proper
use.
86
______________________
www.SeaDooManuals.net