Operating instructions

32
10) Tachometer
(if so equipped)
An analog tachometer indicates the
revolutions per minute (RPM) of the
engine. Multiply by 1000 to obtain the
actual revolutions.
11) Variable Trim System
(VTS) Gauge
(if so equipped)
TYPICAL
1. Bow up
2. Bow down
The VTS gauge shows the riding angle
of the watercraft.
12) Info Center Gauge/
Buttons (if so equipped)
This is a LCD (Liquid Crystal Display)
multifunction gauge.
The MODE button is used to change
display functions.
The SET button is used to set or reset
a function.
It features the following functions:
GSX RFI Models
–clock
–tachometer
– speedometer
– peak speed
– average speed
–trip meter
– engine hourmeter
– water temperature
– chronometer
–VTS (if so equipped)
– fuel level
–low fuel
–low oil
–low voltage
– overheating
– maintenance information
GTX and GTX RFI Models
The info center includes the same
functions as above and features the
following additional ones.
– clock/compass
– exterior temperature
Multifunction Gauge Operation
Display Priorities
The clock/compass function is the ba-
sic mode of the Info Center gauge.
Use the compass as a guide only.
Not to be used for navigation pur-
poses.
The chronometer, tachometer and
speedometer are the only other
modes that may be chosen to replace
the clock/compass mode.
If another mode is chosen, the clock/
compass mode will be displayed again
after 4 seconds.
The Info Center also features a red
warning LED (Light-Emitting Diode)
which blinks whenever one of the fol-
lowing circumstances occur: engine
overheating, low fuel, low oil and low
voltage.
For example, if the fuel level is low, the
LED and the message LOW FUEL will
blink.
As a self test, all LCD segments and
the LED will turn on for 3 seconds each
time the watercraft is started.
F01H4RY
1
2
smo2000-002a.book Page 32 Tuesday, September 28, 1999 12:00 PM
www.SeaDooManuals.net