Operating instructions

78
947 ENGINE
1. Disconnect engine water inlet hose
Install a hose pincher to engine water
inlet hose (except the 947 engine).
717 AND 787 ENGINES
1. Hose pincher installed on the engine water
inlet hose
Temporarily install a short piece of hose
to engine water outlet at cylinder head.
Insert a funnel into hose and pour an-
tifreeze mixed with water in engine un-
til the colored solution appears in the
engine drain hose.
RFI Models
Install a hose pincher to water return
hose of the magneto cooling circuit.
1. Hose pincher to water return hose
Insert a funnel into hose and pour an-
tifreeze mixed with water in engine un-
til the colored solution appears in the
water return hose of the magneto
cooling circuit.
Remove temporary hose and recon-
nect engine water outlet hose.
Remove hose pinchers.
All Models
Most of the antifreeze will drain out
when removing the hose pincher(s).
Use a container to recover it. DISPOSE
ANTIFREEZE AS PER YOUR LOCAL
LAWS AND REGULATIONS.
NOTE: Although antifreeze will mainly
drain out, the antifreeze has mixed with
the water that was possibly trapped in
the water jackets and thus preventing
freezing problems.
At pre-season preparation, drain the
remaining antifreeze from cooling sys-
tem prior using the watercraft.
The following steps should be per-
formed to provide the watercraft en-
hanced protection.
Clean the bilge with hot water and de-
tergent or with bilge cleaner. Rinse
thoroughly. Lift front end of watercraft
to completely drain bilge. If any repairs
are needed to body or to the hull con-
tact your authorized Sea-Doo dealer.
For paint touch up to mechanical parts
use Bombardier spray paint.
F06E05Y
1
F06E0FY
1
F07E07Y
1
smo2000-002a.book Page 78 Tuesday, September 28, 1999 12:00 PM
www.SeaDooManuals.net