Operating instructions

79
Anticorrosion Treatment
Wipe off any residual water in the en-
gine compartment.
Spray BOMBARDIER LUBE lubricant
or equivalent over metallic compo-
nents in engine compartment.
Lubricate the throttle cable with BOM-
BARDIER LUBE lubricant or equiva-
lent.
Final Steps
Apply a good quality marine wax to the
body.
The front and rear portion of the seat (if
so equipped) should be partially left
opened, rear access cover (XP models)
and storage baskets (if so equipped)
should be removed during storage. This
will avoid engine compartment conden-
sation and possible corrosion.
If the watercraft is to be stored out-
side, cover it with an opaque tarpaulin
to prevent sun rays and grime from af-
fecting the plastic components, water-
craft finish as well as preventing dust
accumulation.
CAUTION: The watercraft should
never be left in water for storage.
Never leave the watercraft stored in
direct sunlight.
Pre-Season Preparation
Use the following chart.
Since technical skills and special tools
are required, some operations should
be performed by an authorized Sea-
Doo dealer.

WARNING
Observe all WARNINGS and CAU-
TIONS mentioned throughout this
guide which are pertinent to the
item being checked. When compo-
nent conditions seem less than
satisfactory, replace with genuine
BOMBARDIER parts or approved
equivalents.
smo2000-002a.book Page 79 Tuesday, September 28, 1999 12:00 PM
www.SeaDooManuals.net