Operating instructions

9
Flooded Engine
If the engine does not start and it is
suspected to be flooded, proceed as
follows:
Remove spark plug cables and con-
nect them on the grounding device.
Remove spark plugs and dry them us-
ing a rag.
Cover spark plug holes with a rag.
Install the safety lanyard cap on the
switch.
Depress and hold the throttle lever at
full throttle position.
Depress the start/stop button to crank
the engine approximately 10 seconds.
Proceeding in this order, no fuel is in-
jected and the accumulated fuel in the
engine will be expelled.
Reinstall spark plugs and connect ca-
bles.
Start engine normally without applying
the throttle.
MAINTENANCE
Lubrication
Use SEA-DOO synthetic grease and
lubricate the PTO flywheel every 10
hours. Proceed as follows:
Remove seats to expose engine com-
partment.
Remove the wing nuts, washers and
pull out PTO flywheel guard.
1. Flywheel guard
2. Wing nuts
Using a grease gun, carefully lubricate
PTO flywheel at grease fitting until
boot is just beginning to expand.
1. Grease PTO flywheel
Secure PTO flywheel guard.
◆
WARNING
Always use spark plug cable
grounding device when remov-
ing spark plugs.
◆
WARNING
Always remove safety lanyard
cap from its receptacle to prevent
accidental engine starting before
removing the PTO flywheel
guard.
-
CAUTION
Immediately stop lubricating as
soon as boot begins to expand.
F01I0AY
2
1
F01I0BY
1
smo9803a.fm5 Page 9 Friday, February 20, 1998 3:41 PM
www.SeaDooManuals.net