Operating instructions

11
Unclip and pull out fuse holders to
check fuse condition.
If a fuse is defective, replace it by one
of the same rating.
NOTE: Ensure to properly close cover
of the rear electrical box, making sure
seal is well positioned.
STORAGE
It is recommended that the watercraft
be serviced by an authorized dealer for
storage but the following operations
can be performed by you with a mini-
mum of tools.
Engine Draining
Disconnect the water supply hose
used to cool the magneto. It features
a quick connect fitting. Press both
tabs and pull fitting in order to discon-
nect hose.
This hose is located at the bottom of
the magneto cover beside the engine
support.
1. Disconnect this hose
Water should flow out of the fitting
(magneto cooling circuit) and hose
(crankcase heat exchanger).
1. Make sure water flows out of fitting and
hose
Fuel System
SEA-DOO fuel stabilizer (or equiva-
lent), can be added in fuel tank to pre-
vent fuel deterioration. Follow manu-
facturer’s instructions for proper use.
NOTE: Fuel stabilizer should be added
prior engine lubrication.
-
CAUTION
Do not use a higher rated fuse as
this can cause severe damage.
Refer to SPECIFICATIONS section
for recommended fuse rating. If a
fuse is regularly burnt, refer to an
authorized dealer.
◆
WARNING
If any water is found in the rear
electrical box, immediately refer
to an authorized dealer before
operating the watercraft.
-
CAUTION
Do not run the engine during the
storage period.
-
CAUTION
Water in engine must be free to
flow out. Should water freeze in
engine, severe damage will oc-
cur.
F07E05Y
1
F07E06Y
11
smo9803a.fm5 Page 11 Monday, January 26, 1998 3:55 PM
www.SeaDooManuals.net