Operating instructions

15
PERIODIC INSPECTION CHART
➀ Every 10 hours in salt water use.
➁ These items have to be initially checked after 25 hours. Thereafter, servicing
to be made as specified in this chart.
➂ Daily flushing in salt water or foul water use.
DESCRIPTION
FREQUENCY
every
10 hours
every
25 hours
every
50 hours
every
100 hours
or
seasonally
To be
performed
by
Lubrication/corrosion protection ➀✔OPERATOR
Engine ignition timing ✔ DEALER
Spark plug replacement ✔ DEALER
Fuel injector cleaning ✔ DEALER
Fuel injection sensors verification ✔ DEALER
Throttle cable, inspection/lubrication ➀✔ OPERATOR
Throttle cable adjustment ✔ DEALER
Oil injection pump adjustment ✔ DEALER
Oil filter inspection ✔ DEALER
Oil filter replacement ✔ DEALER
Fuel tank straps ✔ OPERATOR
Oil tank straps ✔ OPERATOR
Engine head bolts, retorque ✔ DEALER
Engine counterbalance shaft oil level ✔ DEALER
Steering system ✔ DEALER
Reverse system/reverse cable adjustment ✔ DEALER
Fastener tightening (flame arrester, throttle body,
engine mount, exhaust system, etc.)
✔ DEALER
Muffler, battery and reservoir fastening devices ✔ OPERATOR
Fuel lines, check-valve and
fuel system pressurization
✔✔✔ ✔DEALER
Fuel vent line pressure relief valve inspection ✔ DEALER
Battery condition ✔ DEALER
Ground connections (battery, starter, etc.) ✔ DEALER
Monitoring beeper ✔ DEALER
Jet pump reservoir oil level/oil condition ✔ Replace DEALER
Jet pump cover pusher inspection ✔ DEALER
Impeller condition and impeller/wear ring clearance ✔ ➁ DEALER
Drive shaft boot and spline condition ✔ ➁ DEALER
PTO flywheel lubrication ✔ OPERATOR
Seal carrier inspection ✔ DEALER
Water intake grate condition ✔ ➁ OPERATOR
Hull condition ✔ OPERATOR
Cooling system flushing ✔➂ OPERATOR
smo9803a.fm5 Page 15 Thursday, January 29, 1998 8:37 AM
www.SeaDooManuals.net