Operating instructions

22
5) Engine Start/Stop
Button
To start engine, depress and hold the
button. Release immediately after en-
gine is started.
To stop engine, fully release throttle le-
ver then depress the button and discon-
nect safety lanyard from the switch.
1. Engine start/stop button
With the Digitally Encoded Security
System, leaving the safety lanyard for
more than 10 minutes after stopping
the engine will require a slight pres-
sure or the removal and reinstallation
of the safety lanyard on the switch to
allow engine starting.
6) Choke Lever
The choke is provided to supply a rich-
er fuel/air mixture when starting a cold
engine. When the lever is completely
pulled, the choke is fully applied. The
use of the choke is not recommended
with a warm engine.
Choke lever should be pulled and held
to operate. Lever will automatically re-
turn to its normal position when re-
leased.
7) Info Center Gauge/
Switches
This is a LCD multifunction gauge.
The MODE button is used to change
display functions.
The SET button is used to set or reset
a function.
It features the following functions:
– clock/compass
–tachometer
– speedometer
– peak speed
– average speed
– trip meter
– engine hourmeter
– water temperature
– exterior temperature
– chronometer
– fuel level
–low fuel
–low oil
– low voltage
– overheating
– maintenance information
Multifunction Gauge Operation
Display Priorities
The clock/compass function is the ba-
sic mode of the Info Center gauge.
Use the compass as a guide only.
Not to be used for navigation pur-
poses.
The chronometer, tachometer and
speedometer are the only other
modes that may be chosen to replace
the clock/compass mode.
If another mode is chosen, the clock/
compass mode will be displayed again
after 4 seconds.
The Info Center also features a red
warning LED which blinks whenever
one of the following circumstances oc-
cur: engine overheating, low fuel, low
oil and low voltage.
For example, if the fuel level is low, the
LED and the message LOW FUEL will
blink.

WARNING
Directional control is not avail-
able when engine is stopped.
START
STOP
F01L63Y
1
smo2000-001b.fm Page 22 Tuesday, May 4, 1999 1:20 PM
www.SeaDooManuals.net