Operating instructions

24
10) Bilge Drain Plugs
Should water be found in the bilge, it
can be easily drained by unscrewing
the drain plugs.
1. Unscrew
2. Tighten
Tilt the craft slightly to the rear so that
the water can completely flow out of
the bilge.
11) Rear Grab Handles
Provide a handhold for boarding when
needed and a handhold for the passen-
ger.
CAUTION: Never use the grab han-
dle to tow anything or to lift the craft.
12) Seat Strap
The seat strap provides a handhold to
assist boarding and is used as a hand-
hold for the passenger.
13) Swim Platform
Provides a large anti-skid surface for
easy boarding from rear of craft.
14) Seat Latch
Removing the seat allows access to
the engine compartment and to oil
tank cap/dipstick.
The seat latch is located at the rear end
and underneath the seat.
TYPICAL
1. Seat latch
To remove seat, it is necessary to re-
move the rear portion of the seat first
pull the latch lever upward and hold.
Lift and pull the seat rearward.
Repeat same procedure to remove the
front portion of the seat.
When reinstalling the seat, insert seat
front tab into body hook for each por-
tion of the seat.
TYPICAL
1. Insert this tab in hook
2. Hook
Pull latch lever to insert it over the rear
lock pin. Release latch lever then firmly
push on rear of the seat to relatch.

WARNING
Make sure drain plugs are proper-
ly secured prior launching the
craft in water.
F02L2FY
1
2

WARNING
Periodically verify the seat lock
pin and tighten if needed. Make
sure seat is securely latched.
F11L09Y
1
F01L92Y
12
smo2000-001b.fm Page 24 Tuesday, May 4, 1999 1:20 PM
www.SeaDooManuals.net