Operating instructions

27
25) Flushing Connector
To flush engine. Refer to POST-
OPERATION CARE section for
proper use.
26) Bow and Stern Eyelets
Bow Eyelet
Eyelets can be used for mooring, tow-
ing and as a tie-down point during
transportation.
TYPICAL
1. Bow eyelet
This eyelet allows a rope with a hook,
a closes end or an open end to be at-
tached.
Stern Eyelet
TYPICAL
1. Stern eyelet
27) Jet Pump Nozzle
Jet pump nozzle turns side to side via
rider input at the handlebar. This pro-
vides directional control when engine
is running.
28) Reverse Gate
When selecting the neutral or reverse
position with the shift lever, the re-
verse gate moves up or down to obtain
the desired position.
29) Scupper Valves
This is where water from deck drains
out. Keep clean to avoid clogging.
30) Cooling System Bleed
Outlet(s)
1. Bleed outlet
When engine is running, water should
flow from the outlet. This allows air in
engine cooling system to escape. It
also indicates that water is circulating
in the cooling system.
F00L0EY
1
F01L9DY
1

WARNING
Never use nozzle as a supporting
point to board the craft or to lift it.

WARNING
Never use gate as a supporting
point to board the craft. Do not re-
verse while at speed.
F01L9DZ
1
smo2000-001b.fm Page 27 Tuesday, May 4, 1999 1:20 PM
www.SeaDooManuals.net