Operating instructions

28
NOTE: It may be required to increase
slightly the engine RPM to see the wa-
ter flowing out.
CAUTION: Should water not flow
from outlet a few seconds after en-
gine starts, immediately stop en-
gine and refer to POST-OPERATION
CARE and look for cooling system
flushing or refer to an authorized
Sea-Doo dealer for servicing.
31) Jet Pump Water Intake
The water is drawn up by the impeller
through this opening. Grate minimizes
the entry of foreign objects into the
propulsion system.
TYPICAL
1. Water intake
32) Automatic Bilge Pump
Bilge pump evacuates water from the
bilge.
When safety lanyard cap is plugged to
the switch bilge pump automatically
turns on. It will stay on for 30 seconds.
When engine is started bilge pump re-
mains on and stays on until engine is
stopped.
When engine is stopped pump re-
mains on for 30 seconds and then au-
tomatically shuts-off.
33) Boarding Step
A convenient step to help reboarding
the craft.
TYPICAL
1. Boarding step
34) Sun Deck
A convenient space to rest or take
some sun while anchored.
35) Tool Kit
Contains tools needed to perform ba-
sic craft maintenance.
F01J3ZY
1

WARNING
Engine should be OFF when us-
ing boarding step. Keep limbs
away from jet or intake grate.
Stay on center of the step. Only
one person at the time on the
step. Never use the step for pull-
ing, towing, diving or jumping,
boarding a PWC that is out of wa-
ter or any other purpose other
than a boarding step.

WARNING
Do not start or operate the craft if
a person(s) is seated on the sun
deck or swim platform.
F07L1HY
1
smo2000-001b.fm Page 28 Tuesday, May 4, 1999 1:20 PM
www.SeaDooManuals.net