Operating instructions

42
TYPICAL
1. Flushing connector
2. Quick connect adapter (not mandatory)
3. Garden hose
Start the engine then immediately
open the water tap.
CAUTION: Never flush a hot engine.
Always start the engine before
opening the water tap. Open water
tap immediately after engine is
started to prevent overheating.
Run the engine about 3 minutes at a
fast idle around 3500 RPM.
CAUTION: Never run engine longer
than 5 minutes. Drive line seal has
no cooling when craft is out of wa-
ter.
Lubrication
Spray BOMBARDIER LUBE lubricant
or equivalent, through hole of air intake
silencer keeping engine at fast idle
during one minute.
TYPICAL
1. Air intake silencer
2. Spray BOMBARDIER LUBE here
NOTE: After approximately half a
minute, close fuel valve to run engine
out of fuel while lubricating.
CAUTION: When engine begins to
run irregularly because of fuel star-
vation, immediately stop water flow
before engine dies.
Close the water tap then stop the en-
gine.
Final Steps
Disconnect the garden hose.
Remove spark plug cables and con-
nect them on the grounding device.
Remove both spark plugs and spray
BOMBARDIER LUBE lubricant or
equivalent into each cylinder.
Crank the engine a few turns to distrib-
ute the oil on cylinder wall.

WARNING
Do not touch any electrical parts
or jet pump area when engine is
running.
F07E01Y
3
21

WARNING
Always use spark plug cable
grounding device when remov-
ing spark plugs.
F06F0CY
1
2
smo2000-001b.fm Page 42 Tuesday, May 4, 1999 1:20 PM
www.SeaDooManuals.net