Operating instructions

46
MAINTENANCE
Lubrication
Use SEA-DOO synthetic grease or
equivalent and lubricate PTO flywheel,
see MAINTENANCE Periodic Inspec-
tion Chart.
Proceed as follows:
Remove seat(s) to expose engine com-
partment.
PTO Flywheel
Remove the wing nuts, washers and
pull out PTO flywheel guard.
TYPICAL
1. Flywheel guard
2. Wing nuts
Using a grease gun, carefully lubricate
PTO flywheel at grease fitting until
PTO flywheel boot begins to expand.
CAUTION: Immediately stop lubri-
cating as soon as PTO flywheel boot
begins to expand to prevent dam-
age or slipping.
1. PTO flywheel
2. Grease fitting
3. PTO flywheel boot
Reinstall and secure PTO flywheel
guard.
Anticorrosion Protection
Throttle/Choke Cables
Lubricate the throttle and choke cables
with BOMBARDIER LUBE lubricant or
equivalent every 25 hours (or every 10
hours in salt water use).
Electrical Connections
As necessary, apply dielectric grease
on battery posts and all exposed cable
connectors.
CAUTION: Do not lubricate connec-
tors of the Multi-Purpose Electronic
Module.
Additional Lubrication
BOMBARDIER LUBE lubricant or equiv-
alent will help prevent corrosion and
maintain proper operation of moving
mechanisms.
Lubrication of the following items
should be performed every 50 hours in
fresh water use but every 10 hours in
salt water use.

WARNING
Only perform procedures as de-
tailed in this guide. It is recom-
mended that the assistance of an
authorized Sea-Doo dealer be pe-
riodically obtained on other com-
ponents/systems not covered in
this guide. Unless otherwise spec-
ified, engine should not be run-
ning and the safety lanyard should
be removed from its switch for all
maintenance procedures.
F01I0AY
2
1
F01I0BZ
2
1
3
smo2000-001b.fm Page 46 Tuesday, May 4, 1999 1:20 PM
www.SeaDooManuals.net