Operating instructions

48
Periodic Inspection Chart
NOTE: Some items are included in the PRE-OPERATION CHECKS and not nec-
essarily repeated in this chart.
Every 10 hours in salt water use.
These items have to be initially checked after 25 hours. Thereafter, servicing
to be made as specified in this chart.
Daily flushing in salt water or foul water use.
DESCRIPTION
FREQUENCY
Every
10
hours
Every
25
hours
Every
50
hours
Every
100
hours or
seasonally
To be
performed
by
Lubrication/corrosion protection
OPERATOR
Engine ignition timing
DEALER
Spark plug replacement
DEALER
Throttle/choke cables, inspection/lubrication
OPERATOR
Carburetor adjustment including choke/
throttle cable adjustments
DEALER
Oil injection pump adjustment
DEALER
Fuel filter and oil filter inspection
DEALER
Fuel filter and oil filter replacement
DEALER
Fuel tank straps
OPERATOR
Oil tank straps
OPERATOR
Engine head bolts, retorque
DEALER
Engine counterbalance shaft oil level (if applicable)
DEALER
Steering system
DEALER
Reverse system/reverse cable adjustment
DEALER
Fastener tightening (flame arrester, carburetor(s),
engine mount, exhaust system, etc.)
DEALER
Muffler, battery and reservoir fastening devices
OPERATOR
Fuel lines, check-valve and fuel system pressurization
DEALER
Fuel vent line pressure relief valve inspection
DEALER
Inspect/clean engine drain tube
DEALER
Battery condition
DEALER
Electrical connections (battery, starter, etc.)
DEALER
Monitoring beeper
DEALER
Jet pump reservoir oil level/oil condition
Replace DEALER
Jet pump cover pusher inspection
DEALER
Impeller condition and impeller/wear ring clearance
DEALER
Drive shaft boot and spline condition (if applicable)
DEALER
PTO flywheel and seal carrier lubrication (if applicable)
OPERATOR
Water intake grate condition
OPERATOR
Hull condition
OPERATOR
Cooling system flushing
OPERATOR
smo2000-001b.fm Page 48 Tuesday, May 4, 1999 1:20 PM
www.SeaDooManuals.net