Operating instructions

53
Anticorrosion Treatment
Wipe off any residual water in the en-
gine compartment.
Spray BOMBARDIER LUBE lubricant
or equivalent over metallic compo-
nents in engine compartment.
Lubricate the throttle cable with BOM-
BARDIER LUBE lubricant or equiva-
lent.
The front and rear portion of the seat
should be partially left opened and
storage baskets should be removed
during storage. This will avoid engine
compartment condensation and possi-
ble corrosion.
Antifreezing Protection
In cool regions (where freezing point
may be encountered), cooling system
should be filled with an equal part of
water and antifreeze solution.
CAUTION: Always use ethylene gly-
col antifreeze containing corrosion
inhibitors specifically recommend-
ed for aluminum engines.
Install a hose pincher to engine drain
hose.
TYPICAL
1. Hose pincher installed on engine drain hose
Disconnect engine water outlet hose.
TYPICAL
1. Disconnect engine water inlet hose
Temporarily install a short piece of
hose to engine water outlet at cylinder
head.
Insert a funnel into hose and pour an-
tifreeze mixed with water in engine un-
til the colored solution appears in the
engine drain hose.
Most of the antifreeze will drain out
when removing the hose pincher(s).
Use a container to recover it. DISPOSE
OF ANTIFREEZE AS PER YOUR LO-
CAL LAWS AND REGULATIONS.
NOTE: Although antifreeze will mainly
drain out, the antifreeze has mixed
with the water that was possibly
trapped in the cylinder water jackets
and thus preventing freezing prob-
lems.
At pre-season preparation, drain the
remaining antifreeze from cooling sys-
tem prior using the craft.
The following steps should be per-
formed to provide the craft enhanced
protection.
Lubricate the throttle cable with BOM-
BARDIER LUBE lubricant or equiva-
lent.
F06E0DY
1
F06E05Y
1
smo2000-001b.fm Page 53 Tuesday, May 4, 1999 1:20 PM
www.SeaDooManuals.net