Operating instructions

28
From the forward position, pull the le-
ver to reverse. Push back to go to for-
ward. Always set in forward when fin-
ished. To find the neutral, set in
reverse then push back until the wa-
tercraft stops moving backwards.
TYPICAL — FORWARD POSITION
TYPICAL — NEUTRAL POSITION
TYPICAL — REVERSE POSITION
6) Speedometer
Analog speedometer indicates the
speed of watercraft in miles per hour
(MPH) and kilometers per hour (km/h).
The speed sensor mounted on the ride
plate sends the signal to the speedom-
eter and information center.
7) Information Center
Gauge/Buttons
(if so equipped)
NOTE: With the safety lanyard discon-
nected, information center can be ac-
tivated for approximately 33 seconds
by depressing the engine start/stop
button. This is convenient to see the
fuel level or view some other functions
when the safety lanyard is not at hand.
This is a LCD multifunction gauge. Dif-
ferent displays and functions can be
activated using 2 buttons — MODE
and SET — following specific sequenc-
es as described below.
1. To change display mode
2. To set or reset a function
Resetting a Function
To reset a function (such as the chro-
nometer, distance, etc.) press and hold
the SET button for 2 seconds while in
the appropriate mode.
F17L0AY
F17L0BY
F17L0CY
F00L2BY
12
smo2003-005a.book Page 28 Friday, November 1, 2002 8:25 AM