Operating instructions

29
The information center includes the fol-
lowing display areas.
1. General display
2. Message/units display
3. Warning light
4. Fuel level display
5. VTS position indicator (if so equipped)
General Display
The default display is the clock (or
clock/compass if so equipped) unless
another mode has been selected. See
Display Priorities below.
Repeatedly pressing the MODE button
scrolls the following displays: Tachom-
eter, speedometer, average speed, trip
meter, hourmeter, water temperature,
exterior temperature (if so equipped)
and chronometer.
1. Press to change display mode
When you are satisfied with your choice,
stop pressing the button.
Clock: Indicates the actual time in hours
and minutes (hh:mm).
Clock/Compass (if so equipped): Dis-
plays the cardinal points to indicate the
orientation of the watercraft.
Tachometer: Indicates the revolutions
per minute (RPM) of the engine.
Speedometer: Indicates the speed of
watercraft in kilometers per hour (KPH)
or miles per hour (MPH).
Average Speed: The information cen-
ter approximately calculates and dis-
plays the average speed (AV KPH or
AV MPH) of the watercraft since the
last engine start.
Trip Meter: The information center ap-
proximately calculates the distance
based on the operation time and the wa-
tercraft speed and displays the result in
kilometers (KM) or miles (MILES).
Hourmeter: Displays the time in hours
of the watercraft usage.
Water Temperature: Displays the wa-
ter temperature (L TEMP) in degrees
Celsius (°C) or Farenheit (°F).
Exterior Temperature (if so equipped):
Displays the exterior air temperature
(E TEMP) in degrees Celsius (°C) or Fahr-
enheit (°F).
Chronometer: Allows to measure an
interval of time in hours and minutes
(hh:mm).
F00L2CY
34
512
F00L2BZ
1

WARNING
Use the compass as a guide only.
Not to be used for navigation pur-
poses.
smo2003-005a.book Page 29 Friday, November 1, 2002 8:25 AM