Installation Guide

A. Use a listed wire connector to connect the fixture hot wire (black

wire, or round and smooth tracer) to the supply hot wire.

B. Use a listed wire connector to connect the fixture common wire

(white wire, or square and rigid) to the supply common wire.

C. Gently try to remove the wires from the connector. If you can

remove the wires, carefully re-do the wiring connection.

ecure mounting bar (A) to outlet box with outlet box screws (not

supplied). Thread nut (B) on nipple (C) so that 3 threads are exposed

above nut (B). Thread nipple (C) into mounting bar (A) and secure

with nut (B). Thread screw collar (E) to nipple (C).

STEP 1:

sing 2 pairs of pliers or chain breaks, open one link of chain (H) and

connect it to the fixture loop (I) at the top of the fixture. Please be

sure to open chain link outwards. Do not twist.

STEP 2:

Slide the screw collar ring (F) and canopy (G), in that order, over

chain (H). Open one link on the other end of the chain (H) and attach

it to the screw collar (E) which has been mounted to the nipple (C).

BE SURE TO CLOSE ALL CHAIN LINKS COMPLETELY.

STEP 3:

INSTALLATION HC-1570

STEP 4:

STEP 5:

GROUNDING INSTRUCTIONS

Connect the supply ground wire, fixture ground wire, and mounting bar

ground wire (pre attached) using the supplied wiring connector. Gently try

to remove the wires from the connector. If you can remove the wires,

carefully re-do the wiring connection.

fter wires are connected, tuck them carefully inside outlet box.

Raise canopy (G) against ceiling and thread the screw collar ring (F)

to the screw collar (E).

Make sure no bare wires can be seen outside wire connectors.

nstall lamp (not supplied).

FINAL ASSEMBLY

STEP 6:

TEP 7:

Raise cage assembly (L) to fixture and secure using supplied

retaining screws (M).

STEP 8:

IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX

WITHOUT THE USE OF A MOUNTING BAR.