Installation Sheet

Installation Instructions for

Barn Light Outdoor Wall

1.0

990W8_37401-BRL

8537401, 8637401, 8737401, 8837401

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing compliant junctionNEC

boxes.

This product is safety listed for wet locations.

Incandescent version may be dimmed with a standard incandescent dimmer.

LED LEDversion may be dimmed with a dimmer. Consult lamp manufacturer

for additional information.

This instruction shows a typical installation.

CAUTION RISK OF FIRE-

This product requires installation by a qualified electrician.

Before installing be sure to read all instructions and

TURN THE POWERTO THE ELECTRICAL BOX OFF.

CAUTION RISK OF FIRE-

This product must be installed in accordance with the applicable

installation code by a person familiar with the construction and

operation of the product and the hazards involved.

Use minimum 90°c supply conductors.

7400 Linder Ave, Skokie, 160077IL

800.969.3347

www.generationlighting.com

The "Generation Lighting" graphic is a registered trademark of

Generation Lighting. Generation Lighting reserves the right to

change specifications for product improvements without notification.

Outdoor

SAVETHESE INSTRUCTIONS!

PAGE 1
Installation Instructions for 990W8_37401-BRL Barn Light Outdoor Wall 8537401, 8637401, 8737401, 8837401 1.0 CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code CAUTION by a person familiar construction and - RISKwith OF the FIRE operation of the product and the hazards involved. This product requires installation by a qualified electrician. Outdoor BeforeUse installing be sure to read supply all instructions and minimum 90°c conductors.
PAGE 2
Install the Fixture 1A CAP NUT NEUTRAL WIRE ARM EXTENSION WHITE WIRE JUNCTION BOX 6 4 HOT WIRE FIXTURE ALLEN SCREW 7 4 BLACK WIRE MOUNTING PLATE ALLEN WRENCH 10 LAMP 1 Secure the mounting plate to the junction box. 2 Optional: Feed fixture wires through the arm extension and screw the threaded end of the fixture arm into the fixture. 3 Feed the fixture wires into the fixture base. 4 Insert the fixture arm into the fixture base and secure in place with the provided allen screws.