Installation Guide

Installation Instructions for

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing NEC compliant

junction boxes.

This product is safety listed for damp locations.

This product may be dimmed with a standard incandescent dimmer.

This instruction shows a typical installation.

Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.

Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.

Screw the threaded pipe to the bottom of socket assembly.

Place the rubber washer, the shade, and large washer onto the threaded pipe (in that order), then secure them in place

using a hex nut.

Place the decorative cup onto the threaded pipe and secure it in place using the finial.

Vintner 3 Light Semi Flush Mount

1.1

S 317F

Ceiling

S 317F

SHADE

FINIAL

SOCKET ASSEMBLY

CAUTION - RISK OF FIRE

This product must be installed in accordance with the

applicable installation code by a person familiar with the

construction and operation of the product and the hazards

involved.

Use minimum 90°c supply conductors.

DECORATIVE CUP

HEX NUT

LARGE WASHER

THREADED PIPE

RUBBER WASHER

LAMP

PAGE 1
Installation Instructions for SF317 Vintner 3 Light Semi Flush Mount SF317 Ceiling GENERAL PRODUCT INFORMATION: CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is safety listed for damp locations. Use minimum 90°c supply conductors.
PAGE 2
MISE EN GARDE - RISQUE D'INCENDIE Ce produit doit être installé selon le code d’installation pertinent , par une personne qui connaÎt bien le produit et son fonctionnement ainsi que les risques inhérents Les fils d’alimentation doivent convenir pour 90°c.
PAGE 3
ADVERTENCIA - RIESGO DE INCENDIO Este productor debe ser instalado segun el codigo de instalacion aplicable por una persona que conozca la constussion y el funcionamiento del producto y los riesgos que supone. Conductores de alimentacion 90°c Min.
PAGE 4
SAVE THESE INSTRUCTIONS! 555 Theodore Fremd Ave Suite B101 Rye, NY 10580 800.969.3347 www.Feiss.com © 2015 Feiss.All rights reserved.The "Feiss" graphic is a registered trademark of Feiss. Feiss reserves the right to change specifications for product improvements without notification.