Installation Guide

ManualsBrandsSea Gull Lighting ManualsLightingBaffle 4 in. White Recessed Trim

Installation And Safety Instructions

Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to

this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________

HC-933

02308

• Be sure the electricity to the system you are working on is turned off;

either the fuse removed or the circuit breaker set at off.

• Use of other manufacturers components will void warranty, listing and

create a potential safety hazard.

• If you are unclear as to how to proceed, contact a qualified electrician.

• You don’t need special tools to install this fixture.

• Be sure to follow the steps in the order given.

• Read instructions carefully.

• Save these instructions.

IMPORTANT SAFETY INSTRUCTIONS

TORSION

SPRINGS

SLOTTED

TABS

TORSION

SPRINGS

TRIM

PRESSURE

SPRINGS

PRESSURE

SPRINGS

TRIM

COIL

SPRINGS

SLOT HOOK

SPRINGS HERE

COIL

SPRING

TRIM

Carefully remove the fixture from the carton and check that all parts

are included, as shown in Figure 1 & 2. Be careful not to misplace

any of the screws or parts which are needed to install this fixture.

BEFORE YOU BEGIN

ORSION SPRINGS:

queeze the arms together

and insert them into the slotted tabs on the inside of the housing.

Push upward fully so springs will hold trim in place (see Diagram 1).

PRESSURE SPRINGS: Bend slotted tabs up and insert trim into

housing. Push upward fully and pressure springs will hold trim in

place (see Diagram 2).

COIL SPRINGS: Y

ou must bend the slotted tabs back up out of the

way (just push upwar

d withfinger). Then hook the coil springs into the

slots cut into the sides of the housing

(see Diagram 3).

INSTALLATION

Summary of content (2 pages)

PAGE 1
Installation And Safety Instructions HC-933 Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________ IMPORTANT SAFETY INSTRUCTIONS • • • • • • • Be sure the electricity to the system you are working on is turned off; either the fuse removed or the circuit breaker set at off.
PAGE 2
INSTALLATION HC-933 COIL SPRINGS FOR IC HOUSING: Hook the coil springs into the slots cut into the slots on the socket plate (using a pencil or small object may be necessary) (see Diagram 4). COIL SPRINGS (FOR IC HOUSING) FOR AT TRIMS: • Position gasket on trim. • Press gasket ground lip of trim (See figure 7). • Install trim by one of the following methods.