OWNER’S MANUAL Ceiling Fan Installation Instructions QUALITY CEILING FAN For Quality Pro Series Fans 15160B-255,15161B-191,15162B-15 15163B-191, 15270B-255 Total fan weight with light kit READ AND SAVE THESE INSTRUCTIONS
INSTALLATION SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes ANSI/NFPA 70-1999), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer. 3.
7 8 Black White Ground Hang assembled fan from the mounting bracket installed to ceiling in previous step. Make sure the fan is hanging straight. Rotate fan until the tab on the Mounting bracket engages the slot on the Downrod Ball. This must be done to prevent the fan body from rotating when the blades are in motion. 10 House Fan 9 Blue Black White Green Connect black and blue wire from fan to Black or (Hot) wire from house. Connect White wire from Fan to White (Neutral) wire from house.
21 20 19 Hands free hook Replace the 3 screws removed and tighten securely. Check motor for shipping stabilizers and remove if present. 22 Black White Ground House Fan Remove the all thread studs from the lower part of the mounting bracket. Hang fan from mounting bracket by the hands free hook into a closed hole on the edge of the Canopy. . 23 Take 4 screws from hardware pack and insert 2 one on each side of bracket to match the L slot screw holes in canopy. Keep 2 screws for later use.
31 32 33 Locate blue and white wire from the fan marked “For light kit”. Connect blue from fan to black from light and white from fan to white from light by pushing connectors together. Remove 3 screws and washers from switch cap. Place the light fitter and tighten with screws and washers. 34 35 36 Remove finial nut, finial cap, hex nut, and washer from fitter. Install rubber washer and nut to glass tighten nut. Install finial cap and finial nut to glass and tighten finial nut.
TROUBLE SHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.