590-CUL-ENG Owner’s Manual Ceiling Fan Installation Instructions Total fan weight with light kit For 1590 Series Fans READ AND SAVE THESE INSTRUCTIONS HC-807
1590-CUL-ENG Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70-1996), including fire-rated construction. Use this unit only in the manner intended by the manufacturer.
1590-CUL-ENG 7 8 Carefully lift fan assembly onto mounting bracket. Rotate fan so that the notch on the ball engages the ridge in the mounting bracket. This will allow hands-free wiring. 10 9 Before installing the remote receiver. Make sure the DIP switches in the Transmitter and receiver are set the same. Use instrument with a sharp point to move the switches into the proper positions. The Remote will not operate if this procedure is not done.
1590-CUL-ENG 17 Install twin circular fluorescent tube to fan. 20 18 Plug ballast into the fluorescent tube. 21 19 Carefully place fluorescent lamp into clips on fan. (see insert) 22 Light control button Battery compartment Fan on/off Foward/reve rse button Fan speed controls Install finial cap and glass to fitter body. Install finial nut and tighten. Install glass bowl. Install 9v battery by removing battery cover on back of transmitter and connecting to terminals and re-install cover.
1590-CUL-ENG Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.