Installation Guide

ManualsBrandsSea Gull Lighting ManualsKitchenCeiling Fan White Wall Control

his fixture is intended for installation in accordance with the National

Electrical Code and local regulations. To assure full compliance with

local codes and regulations, check with your local electrical inspector

before installation. To prevent electrical shock, turn off electricity at

use box before proceeding.

. Before doing any electrical work, turn power off at circut breaker

or fuse box. Wiring must conform to all electrical codes.

2. Remove wall plate and control if any from wall junction box.

. Connect the two black wires on the fan control to the two wires in

the junction box. Using the wire connectors (not supplied). Either

control wire can be connected to either junction box wire.

4. Install fan control into junction box and put on wall plate and

control knob.

5. Rotate knob to “OFF” position and restore power. Fan control is

now operational.

Installation And Safety Instructions

Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to

this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________

HC-440

72109

WIRING DIAGRAM

THIS IS A WIRING DIAGRAM, NOT A MECHANICAL ASSEMBLY OF

THE CEILING FAN. REFER TO FAN INSTRUCTIONS FOR MECHANICAL

ASSEMBLY AND WIRE COLORS.

POWER

SOURCE

120 VOLT

POWER TO

FAN

COMMON

FAN

WIRE

CONNECTOR

JUNCTION

BOX

THREE SPEED CONTROL

120 VOLT 1.25 AMPS

150 WATTS MAXIMUM

FIGURE 1

This fixture is intended for installation in accordance with the National

Electrical Code and local r

egulations. To assure full compliance with

local codes and regulations, check with your local electrical inspector

before installation. To prevent electrical shock, turn off electricity at

fuse box befor

e proceeding.

1. Before doing any electrical work, turn power off at circut breaker