Instructions / Assembly

© Copyright 2000 Seagull Lighting.
11/1/2000 REV. 0
Page-1 HC-425
8
TOOLS REQUIRED
Phillips Screwdriver Step Ladder
1
2
Turn off power at breaker box to
avoid possible electrical shock.
Use metal outlet box suitable for
fan support. Secure outalet box
directly to the building structure
using ceiling joist screws (included).
Junction box must support 35 lbs.
3
5
Remove the downrod ball that was supplied
with your ceiling fan by loosening the set
screw on the side of the ball so that it is no
longer making contact with the downrod.
Slide the downrod ball off the downrod. Be
sure to keep the crosspin supplied with your
fans downrod to use with the Slope
Ceiling Ball. If you are using a longer
downrod you will need to use this
crosspin in your new downrod.
4
Canopy
Mounting
Screws
Install mounting plate to outlet box in ceiling
using the two 8-32 screws and washers
provided with your junction box. Remove the
two canopy mounting screws 180 degrees
apart on outside edge of mounting plate.
Loosen the 2 remaining screws. This will
make installion of the canopy easier in
step 9.
Set Screw
Cross Pin
Existing
Downrod
Ball
Downrod
Slope
Ceiling
Downrod
Ball
9
Rotate canopy clockwise until both
mounting screws drop into slot
recesses. Tighten screws securely.
Install third and fourth screws with
lockwashers into mating holes and
tighten.
Mating
Slots
Mating
Holes
8
Carefully lift fan from mounting plate hook,
making sure not to break any wire connec-
tions. The canopy has (2) mating slots and (2)
mating holes (see illustration above).Position
both slots in canopy directly under and in line
with (2) mounting plate screws and lock
washers. Lift fan until mounting plate
screws are seated in bottom of slots in
canopy.
7
Carefully hang fan onto hook in mounting
plate using one of the two holes in the
canopy. This will allow hands-free
wiring. Refer to your Ceiling fan
Owners Manual for wiring instructions.
6
Feed motor lead wires through downrod/
canopy assembly and insert downrod into
motor yoke. Make sure that the tab in the
canopy engages the notch in the downrod
ball. Install downrod to fan using
instructions provided with your fan
as this may vary from model to
model.
Canopy tab
Downrod
Ball Notch
With your new longer downrod or your
existing downrod, install the Slope Ceiling
Adapter Ball using the crosspin from
your existing downrod. Push Ball up
until it engages the crosspin and
tighten the set screw.
SLOPE CEILING ADAPTER INSTALLATION