Installation Guide

Installation Instructions for

Chandelier

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing compliantNEC

junction boxes.

This product is safety listed for damp locations.

This product may be dimmed with a standard incandescent dimmer.

This instruction shows a typical installation.

CAUTION RISK OF FIRE-

This product requires installation by a qualified electrician.

Before installing be sure to read all instructions and

TURN THE POWERTO THE ELECTRICAL BOX OFF.

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with the

construction and operation of the product and the hazards

involved.

Use minimum 90°c supply conductors.

7400 Linder Ave, Skokie, 160077IL

800.969.3347

www.generationlighting.com

The "Generation Lighting" graphic is a registered trademark of

Generation Lighting. Generation Lighting reserves the right to

change specifications for product improvements without notification.

SAVETHESE INSTRUCTIONS!

Oglesby Chandelier

1.0

990CH310190_-OGB

3101902, 3101903, 3101904, 3101905

PAGE 1
Installation Instructions for 990CH310190_-OGB Oglesby Chandelier 3101902, 3101903, 3101904, 3101905 1.0 CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person CAUTION - RISK OFfamiliar FIRE with the construction operation of the by product and the hazards This product and requires installation a qualified electrician. involved. Before installing be sure to read all instructions and Chandelier TURN THE POWER TO THE ELECTRICAL BOX OFF.
PAGE 2
Install the Fixture 1A JUNCTION BOX 14 13 MOUNTING PLATE THREADED NIPPLE SCREW COLLAR CANOPY HUB COLLAR NUT CHAIN HOOK 4 FIXTURE LOOP LONG STRAND HUB LONG STRAND STEM LONG STRAND 4 LAMP 4 FIXTURE RING 5 3 5 SHORT STRAND SHORT STRAND 1 If necessary, screw the shorter end of the threaded nipple tightly onto the mounting plate and the screw collar onto the threaded nipple. 2 Secure the mounting plate to the junction box.