Installation Guide

Install the Fixture

Use MAX 75 Watt120 volt

Type A19 Medium Base Lamp.

NOTE: Due to the complexity of this fixture,

assistance will be needed for installation.

Place the safety cable with washers on each side to the shorter end of the threaded nipple and screw it tightly onto the mounting

plate.

Secure the mounting plate to the electrical box with two mounting plate screws.

Secure the safety cable to a secure solid structure in accordance with local building code.

Screw the screw collar tightly onto the threaded nipple.

Screw the fixture loop onto the fixture.

Determine the wanted height of the fixture and remove a portion of the chain by opening a link and removing it from the bottom.

Install the canopy and the collar nut onto the chain (in that order ) then install the open link onto the fixture loop and secure it in

place by closing the link.

Weave the cord through the chain, screw collar, canopy, threaded nipple, and out of the electrical box. Trim the cord leaving enough

to make electrical connections.

Connect the fixture to a suitable ground in accordance to local electrical codes.

Connect the white fixture wire (square and rigid tracer) to the neutral power line wire with a wire nut.

Connect the black fixture wire (round and smooth tracer) to the hot power line wire with a wire nut.

Neatly place all the wires into the electrical box, place the canopy onto the ceiling, and secure it in place by screwing the collar nut

tightly onto the screw collar.

Place the shade and spacer onto the shade base and secure them in place by installing and tightly screwing the shade collar nut

onto the socket; repeat for all shades.

Screw the lamps in to the sockets.

Screw the finial onto the fixture.

ELECTRICAL BOX

MOUNTING PLATE SCREW

CANOPY

COLLAR NUT

FIXTURE LOOP

CHAIN

SCREW COLLAR

THREADED NIPPLE

MOUNTING PLATE

LAMP

SHADE

SHADE BASE

SOCKET

SHADE COLLAR NUT

SPACER

SAFETY CABLE

Use MAX 100 Watt120 volt

Type A19 Medium Base Lamp.

FINIAL