Installation Guide

IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET
BOX.
Thread mounting screws (F) into holes of universal mounting bar (D)
and run mounting screws (F) all the way down to their heads.
Make sure no bare wires can be seen outside wire connectors.
Place glass (J) around socket and secure in place by tightening glass
retaining screws (L). Finger tighten only. Do not over tighten.
Install lamps.
After wires are connected, tuck them carefully inside outlet box. Push
the backplate (C) firmly over the mounting screws (F) and against the
wall. Secure backplate (C) in place by threading cap nuts (H) onto
mounting screws (F).
Using outlet box screws (not supplied) fasten universal mounting bar
(D) to outlet box through slots in universal mounting bar (D). Make
sure mounting screws (F) are perfectly horizontal so fixture hangs
properly.
A. Take note of the color of the wire(s) on your fixture. Identify which
group your fixture wire(s) falls into and connect the wires according to
the directions below:
*Note: When parallel wire is used, the tracer wire is square shaped or
ridged and less tracer wire is round in shape or smooth. (Seen best
when viewed from wire end.) To separate wires, grasp the ends of
each wire and pull apart.
B. Take your fixture wire(s) from group A and place evenly against
the black wire from the outlet box.
DO NOT twist wires together
before using wire connectors.
C. Fit a wire connector (not supplied) over the wires and thread the
connector clockwise until you feel a firm resistance.
D. Gently try to remove the wires from the connector. If you can
remove the wires, carefully re-do steps B and C, as above and check
again for a firm connection.
E. Connect the fixture wire from group B to the white wire from the
outlet box in the same manner.
GROUNDING INSTRUCTIONS: The green grounding screw (G) is to
be inserted into the hole with two raised dimples provided on the
universal mounting bar (D). Wrap the ground wire from the fixture (if
supplied) and the ground wire from the outlet box (bare metal or
green insulated wire) around the green grounding screw (G) on the
universal mounting bar (D) if uninsulated wire is on the universal
mounting bar (D), connect the ground wire from the fixture (if
supplied) and the outlet box to it using a small wire connector (not
supplied).
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE
POWER SUPPLY WIRES.
GROUP A: CONNECT TO BLACK
HOUSE WIRE
BLACK
WHITE
*
PARALLEL WIRE (ROUND & SMOOTH)
*PARALLEL WIRE (SQUARE & RIDGED)
GROUP B: CONNECT TO WHITE
HOUSE WIRE
To clean, wipe fixture body with a soft cloth. Clean glass with a mild
soap. Do not use abrasive materials such as scouring pads or
powders, steel wool, or abrasive paper
.
Keep this sheet for future reference, and in case you need to order
replacement parts. Parts for this fixture can be ordered from place of
purchase. Be sure to use exact wording from illustration when
ordering parts.
I
NSTALLATION HC-1329
S
TEP 4:
STEP 1:
STEP 2:
STEP 3:
FINAL ASSEMBLY
STEP 1:
S
TEP 2:
STEP 3:
STEP 4:
CLEANING
ORDERING PARTS