Installation Guide

Carefully remove the fixture from the carton and check that all parts
are included, as shown in figure 1. Be careful not to misplace any of
the screws or parts which are needed to install this fixture.
*OUTLET
BOX
CANOPY
(F)
FIGURE 1
UNIVERSAL
MOUNTING
BAR (J)
GLASS (A)
MOUNTING
SCREWS (I)
GREEN
GROUNDING
SCREW (L)
FIXTURE
GROUND
WIRE (H)
•
Be sure the electricity to the system you are working on is turned
off; either the fuse removed or the circuit breaker set at off.
• Use of other manufacturers components will void warranty, listing
and create a potential safety hazard.
• If you are unclear as to how to proceed, contact a qualified electrician.
•
You don’t need special tools to install this fixture.
• Be sure to follow the steps in the order given.
• Proper wiring is essential for the safe operation of this fixture.
•
Read instructions carefully.
• Save these instructions.
CAP
NUTS
(J)
Installation And Safety Instructions
Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to
this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________
HC-909
0
50812
IMPORTANT SAFETY INSTRUCTIONS
BEFORE YOU BEGIN
T
o clean, wipe fixture with a soft cloth. Clean glass with a mild soap.
Do not use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
K
eep this sheet for future reference, and in case you need to order
replacement parts. Parts for this fixture can be ordered from place of
purchase. Be sure to use exact wording from illustration when
ordering parts.
CLEANING
ORDERING PARTS
Insert fixture mounting screws (I) into threaded holes of universal
mounting bar (J). Run screws all the way down to the heads.
Place universal mounting bar (J) against outlet box (not supplied) and
screw in place using outlet box screws (K) (not supplied). Be sure the
mounting screws are perfectly vertical so fixture hangs straight.
IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX.
STEP 1:
STEP 2:
INSTALLATION
*OUTLET BOX
SCREWS (K)
*WIRE
CONNECTORS
SOCKET
CUP (B)
*HOUSE
GROUND
WIRE
*NOT INCLUDED
GLASS
RETAINING
SCREWS
(C)