Installation Guide

2
1A
Secure the mounting plate to the electrical box with two mounting plate screws. For single light fixture,Note:
mounting plate studs must face horizontally.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Align, then place the fixture base onto the mounting plate studs and secure it with the two cap nuts.
Install the shade by properly placing it over the socket and screwing the collar nut tightly onto the socket.
Screw the lamp into the socket.
If necessary, repeat steps 6-8 for remaining sockets.
1
2
3
4
5
6
3
4
5
ELECTRICAL BOX
NEUTRAL WIRE
HOT WIRE
WHITE WIRE
BLACK WIRE
MOUNTING
PLATE STUD
MOUNTING
PLATE SCREW
FIXTURE BASE
CAP NUT
LAMP
Install the Fixture
MOUNTING
PLATE
6
SHADE
SOCKET
SHADE BASE
1
1
7
8
7
COLLAR NUT
Use 120 volt,MAX 100 Watt
Type A19 Medium Base Lamp.
5